Ameritec - 30-0056 - Interface
Manufacturer:
Image 1 of 1
If you have any other photos or manuals for the
Ameritec 30-0056
you can
upload the files here.
Equipment:
30-0056
Date:
2000
Category:
Group:
Sub Group:
Information
The Model 300056 AM8e E&M Adapter is physically designed to
replace the front
cover of the Call Analyzer. The illustration on the cover of
this manual shows both
units as they would be set up for use.
Note: F or brevity, the Model 300056 AM8e E&M Signaling
Adapter will be referred
to as the "E&M Adapter".
The E&M Adapter is electrically connected to the Call
Analyzer via a ribbon cable
from a "TO AM8e" connector on its front panel to the
LINE/TIMS connector on the
rear panel of the Call Analyzer. All power and PCM2 input
and output connections
between the E&M Adapter and the Call Analyzer are via this
connector.
The interfaces between the E&M signaling and VF circuits are
via bantam jacks on
the front panel of the E&M Adapter.
Functionally, the E&M Adapter is an Analog to
Digital/Digital to Analog signal
converter, which converts an E&M Signal from its line or
equipment interface at a
Central Office, to 2.048Mbps PCM Rx and Tx Signals, which
are processed by the
Call Analyzer. This allows the Call Analyzer to Emulate or
Monitor either the
near-end (Tx) or far-end (Rx) signaling on an E&M interface.
The user must select
PCM2 as PCM input.
1 Manual
User manual
Manual type:
User manual
Pages:
30
Size:
994.9 KB
Language:
english
Revision:
C
Manual-ID:
18-0044
Date:
October 2000
Quality:
Electronic document, no scan, very well readable.
Upload date:
Oct. 14, 2017
MD5:
3bd77d2c-c970-418d-5f63-db1c329f83b5
Downloads:
334