INTRODUCTION The AM/FM/FM MPX receiver represents the fastest growing segment of the home entertainment electronics market. Many consumers consider the sound system, whether component or console, their first purchase after the essentials of food and shelter. These consumers demand, and are willing to pay relatively large sums for, quality reproduction of their favorite music. When this equipment requires service they expect the repaired unit to meet the same exacting specifications it did when new. The technician who attempts to test, troubleshoot and align a stereo system, costing in some cases thousands of dollars, without proper equipment has a difficult task ahead of him. This need for a reasonably priced stereo analyzer to adequately service and test stereo units prompted Sencore to engineer the SGI65 complete AM/FM/Stereo Analyzer. The SG165, with its accurate temperature compensated solid state circuitry, eliminates the guess work by providing known accurate signals needed for full troubleshooting and performance testing from antenna to speaker terminals. FEATURES * Complete RF coverage of the AM and FM bands, with band edge limits as recommended by receiver manufacturers. * Troubleshooting signals for the FM IF, AM IF, MPX, and audio circuits. * Crystal controlled as well as swept 10.7MHz with post injection crystal controlled 10.7MHz marker, and lOOKHz limit markers for FM IF alignment. * Tight shielding; no RF leakage to cause problems. * 19KHz phase and frequency permanently locked with exclusive Sencore (patent pending) circuit. * Built in 4, 8, 16, and 32 ohm high wattage dummy loads to eliminate the annoying howl in the shop. * Meters calibrated in db of separation and wattage output up to 100 watts full scale. Compensated to read accurate power output for any speaker load resistor. Calibrated RF output for making the all important IHF sensitivity check. Complete with all cables and adapters including dummy auto antenna connector.