The following specification describe the operational characteristics off this series of power supplys. All units are shipped with ac barrier strip located on the back of the unit. Available Rating Sizes: 600W* lOOOW 1800W* 2600W AC Input: 600W - 115 plus or minus 10% - 47-63 Hz 1Q00W — 115 plus or minus 10% 47—63 Hz 1800UJ - 115 plus or minus 10% 47-63 Hz Note: All above units have an optional 208/220 Vac plus or minus 107., 47-63 Hz t 260©W - 208/220 plus or minus 107. 47-63 Hi REGULATION Voltage Mode: For line voltage variations and load current variations within the rating of the supply* the output voltage will not vary more the .IX of maximum voltage rating. Current Mode: For line voltage variations and load voltage variations within the rating of the supply» the output current will not vary more than . 25% of maximum current rating. Ripple: Measured with either positive or negative grounded and 100% output voltage fnd current into a resist ive load. < See Rating Chart) Stability: The output voltage or current will remain with 0.05% for 8 hours after warm-up* with constant external effects. Transient Response: Upon instant application of loads up to 50% or the maximum rating of the supply/ the output voltage will typically recover to within 1 0% of its final value within 50mS Ins tan taneous line variations are corrected for within 50mS of their occurance Temperature Coefficient: Output voltage TC is 0.02% per degree C of maximum rating. Output current T. C. is 0.03% per degree of maximum rating. Operating Temperature 0-50 degrees C with no derating required Consult factory for output rating at higher temperatures