.....obsolete user manuals, a lot of repair manuals, free service manuals, rare schematic diagrams, usefull service instructions, pdf books, how to repair instructions, lost operating manuals, old handbooks, tons of part lists, hidden service bulletins, your instruction books, informative repair tips, complete disassembly routines.....


What are you looking for?

extended search


Rohde & Schwarz AMIQ 1110.2003.02 Generator
Manufacturer:
Model:
AMIQ 1110.2003.02
Date:
1999
Class:
Type:
SubType:
I/Q Modulation Generator

Information

AMIQ is a modulation source for complex baseband signals of state-of-the-art telecommunication networks. Two synchronous outputs, which are matched to each other, and a large memory together with wide analog bandwidth make AMIQ suitable for universal use. AMIQ has been designed to generate I and Q signals in the baseband for present and future types of modulation. "I" stands for the in-phase component, "Q" for the quadrature component. The data to be output by AMIQ are normally calculated by an external workstation (eg PC). To control this calculation, Rohde & Schwarz offers two programs: WINIQSIM and AMIQ Control, a Software for R&S vector signal Generator SMIQ (see Section "Software for AMIQ Control on page 1.8"). The desired information data stream (eg a piece of speech) is generated and a modulation mode selected. Then various interference and distortions (so-called impairments) are superimposed to this (ideal) baseband signal. Thus a long sequence of sample values is obtained, which are loaded into AMIQ (via floppy, IEC/IEEE bus or RS-232 interface). The sequence in the AMIQ memory is then output as analog I and Q signals with the aid of fast and accurate D/A converters. The outputs are (normally) connected to the modulation inputs of an I/Q modulator (eg SMIQ), which modulates the baseband signal onto the desired RF

show more

User Manual
Manual type:
User Manual
Pages:
212
Size:
2.03 Mbytes (2133294 Bytes)
Language:
english
Revision:
Manual-ID:
1110.3339.12-08-
Date:
unknown
Quality:
Electronic document, no scan, very well readable.
Upload date:
2016 12 11
MD5:
25f7051798183147197278f03ff6bcec
Downloads:
1183

Information

Operating Manual The operating manual consisting of a data sheet and 10 chapters contains comprehensive informa- tion on characteristics, putting into operation, operation and remote control of AMIQ: The data sheet informs about guaranteed specifications and characteristics. Chapter 1 describes the operating principle of AMIQ, control elements and connectors on the front and rear panel as well as all procedures required for putting the instru- ment into operation and integration into a test system. Chapter 2 details instrument control via the remote interfaces with the aid of program ex- amples. Chapter 3 presents control and display elements. Chapter 4 describes key operating modes and special characteristics of AMIQ with refer- ence to possible applications. Chapter 5 describes programming of AMIQ, command processing, status reporting system and characteristics of hardware interfaces. Chapter 6 describes the remote-control commands defined for the instrument. At the end of the chapter an alphabetical list of commands is given. Chapter 7 contains program examples for a number of typical applications of AMIQ. Chapter 8 describes preventive maintenance. Chapter 9 gives hints on troubleshooting and contains a list of error messages. Chapter 10 contains an index for the operating manual

show more

Add Comment

* Required information

Comments

No comments yet. Be the first!