Synthesizer -- ARP Instruments Inc. Odyssey 2813
ARP Instruments Inc.
|Category:||Professional music equipment|
Three types of Odyssey models have been produced: I) 2800, 2) 2810-2815 and 3) 2820-2823. The model and serial number are located at the rear or bottom of the Odyssey chassis. Except for 2800, a typical number might read: 2813-0490. For model 2800, the first two digits of the serial number denote the model, such as: 28490. Listed below are the board identification numbers for each model; they will be referenced in the service manual by model number for easy identification. Model Changes The Odyssey has undergone major cosmetic and electrical changes since its original production in 1972, however, the functional capabilities have remained virtually unchanged. The following are the most noticeable physical differences among models: MODEL 2800 Black and white face panel (some later models have black and gold face panels). Pitch Bend knob No Factory installed interface jacks. Wrap around vinyl bottom cover. MODEL 2810-2813 Black and gold face panel. New style power switch. Factory installed interface jacks* Pitch Bend knob. (Some later models have PPC.) Wrap around vinyl bottom cover. MODEL 2820-2823 (current model, Odyssey '78) Black and orange face panel. Steel chassis Leather endblocks - PPC The major electrical changes found in the Odyssey-II as compared to the Odyssey-I are: 1. Uses 24db/octave filter in place of 12db/? octave. 2. Improved VCO design for better tracking# and stability. 3. Improved Power Supply regulation. 4. Improved Keyboard current source for CV generation. 5. Improved S/H memory circuit design.
These manuals for the ARP Odyssey 2813 Synthesizer
can you download here for free:
Service Manual -- ARP Instruments Inc. -- Odyssey 2813
|Manual Type:||Service Manual|
|Size:||11.54 Mbytes (12101282 Bytes)|
|Date:||01 January 1978|
|Quality:||Scanned document, reading partly badly, partly not readable.|
|Upload date:||15 October 2017|
|Downloads:||392 since 15 October 2017|
This service manual is divided into three major sections: A) Circuit Descriptions, B) Trim Procedures, and C) Board Test Points. The circuit descriptions should be consulted when a problem is suspected in a particular area of the instrument. The trim procedures should be used to verify calibrations or when a component has been changed. The board test points are a quick reference to verify circuits with suspected problems and should be checked whenever a problem has been identified.
|Start Free Download|