Tektronix - 7D20 - Oscilloscope
Manufacturer:
Image 1 of 1
If you have any other photos or manuals for the
Tektronix 7D20
you can
upload the files here.
Equipment:
7D20
Date:
1985
Category:
Group:
Sub Group:
Information
7D20 FEATURES
The 7D20 Programmable Digitizer is designed to enhance
the capabilities of 7000-series oscilloscope mainframes.
Multiple waveform storage, crt readout, two cursors for
point-to-point measurements, pre- and post-trigger
viewing, store and recall of up to six front-panel
settings, and signal averaging to reduce noise are
just a few of the features this three-wide plug-in
unit provides.
Waveform storage using digital memory eliminates the
need for a storage crt, and allows viewing information
that occurred prior to a triggering event Six waveforms
can be stored and displayed at the same time for easy
comparison.
A complete alphanumerical display of cursor waveform
information and measurement values, time base and
amplitude settings, trigger position, displayed waveform
number, prompts and error messages, and a master menu
that allows you to choose seldom used features easily
and quickly.
The master menu offers a convenient way to enable special
functions such as the STORE and RECALL of front-panel
settings as well as allowing you to branch-out to
other menus. The test menu is designed to assist in
troubleshooting the 7D20 in the event of a failure.
The SELF TEST may be implemented at any time to ensure
user confidence. The other selections allow service
personnel to diagnose faults to the component level.
Complete control of the 7D20's functions may be controlled
via the IEEE-488 interface. Commands, waveforms, and
alphanumeric text messages may be sent or received via
the front-panel port.
1 Manual
Service and user manual
Manual type:
Service and user manual
Pages:
394
Size:
89.6 MB
Language:
english
Revision:
Revised
Manual-ID:
070-3858-01
Date:
Quality:
Scanned document, all readable.
Upload date:
April 24, 2013
MD5:
57977624-debc-0ec7-d872-7a55af2c2a98
Downloads:
712