Voltage Range: 0V to 35V Current Range: 0A to 10A Power Range: Up to 175W Output Voltage Setting: By coarse and fine controls. Output Current Setting: By single logarithmic control. Operating Mode: Constant voltage or constant current with automatic cross-over provided that the power demanded stays within the power envelope, see graph. Outside of this envelope the output becomes unregulated. Output Switch: Electronic. Preset voltage and current displayed when off. Output Terminals: Universal 4mm safety binding posts on 19mm (0·75”) pitch. Sensing: Switchable between local and remote. Spring-loaded push terminals for remote connection. Output Protection: Forward protection by Over-Voltage Protection (OVP) trip; maximum voltage that should be applied to the terminals is 50V. Reverse protection by diode clamp for reverse currents up to 3A. OVP Range: 10% to 110% of maximum output voltage set by front panel screwdriver adjustment. Line Regulation: <0.01% of maximum output for a 10% line change. Load Regulation: <0.05% of maximum output for a 90% load change, using remote sense. Ripple & Noise (20MHz bandwidth): 5mVrms max; typically <2mVrms, <20mV pk-pk, both outputs fully loaded (7A @ 25V), constant voltage mode. Transient Load Response: <2ms to within 100mV of set level for a 5% to 95% load change. Temperature Coefficient: Typically <100ppm/°C Status Indication: Output on lamp. Constant voltage mode lamp. Constant current mode lamp. Unregulated (power limit) lamp Trip message on display.