Harvey-Wells Electronic - T-90 - Transmitter
Manufacturer:
Image 1 of 50
If you have any other photos or manuals for the
Harvey-Wells Electronic T-90
you can
upload the files here.
Equipment:
T-90
Date:
Category:
Group:
Sub Group:
Information
The Harvey-Wells T-90 Bandmaster is a versatile VFO and
crystal controlled, bands witching transmitter designed for
use in mobile, portable or fixed installations. It provides
RF output on all amateur frequency bands from 3« 5 to 29.7
mcs , inclusive. The maximum input to the PA stage is 90
watts, CW-ICAS, or it may be operated phone with an input of
75 watts maximum«.
The RF section consists of an oscillator stage followed by
two amplifier-multiplier stages which provide excitation to
the final amplifier stage. The oscillator is of the variable
frequency type but may be operated crystal controlled as an
alternative» The VFO dial scale is calibrated*to the output
frequencies. A three position tap switch in the second
multiplier stage permits adjustment of the PA grid drive by
varying the screen voltageo A protective clamping circuit is
provided to hold down the screen of the Power Amplifier
should excitation fail. The PA plate is coupled to a Pi
network output circuit which is designed to work into a wide
range of antenna load impedances.
The modulator system includes a speech amplifier stage
followed by an amplifier-driver stage which supplies driving
voltage to push“ pull modulators. An internally located two
position slide switch modifies the speech input so that
either carbon, crystal, or high impedance dynamic
microphones may be used· When using carbon microphones,
microphone button voltage is automatically developed in the
speech tube cathode The overall modulation system is
designed for maximum response in the speech range for
increased side-band power.
The T~90 Bandmaster is a complete transmitter, factory wired
and tested, including tubes, less power supply«.
Some of the special features are:
a. TVI Suppression
b. Receiver Muting or Disabling
c. Remote Control Connections
d. Push-to-Talk Operation
e. Zero Beating without Carrier On
f . Antenna Changeover Relay
The heater system of the T-90 is wired in a balanced series-
parallel arrangement and filaments may be operated with
either 6 or 12 volts AC-DC input simply by properly wiring
the power input connector for the correct operating voltage.
1 Manual
Service and user manual
Manual type:
Service and user manual
Pages:
62
Size:
8.9 MB
Language:
english
Revision:
Manual-ID:
Date:
Quality:
Scanned document, reading partly badly, partly not readable.
Upload date:
Aug. 6, 2015
MD5:
3002567d-8a70-2dfa-83b7-0a5734e7a47a
Downloads:
600