The Lafayette 9090 is a highly sophisticated solid-state stereophonic high fidelity receiver that combines an AM tuner, a highly sensitive FM stereo tuner, and a high quality integrated stereo amplifier in one single, handsomely styled unit. The receiver not only offers all the advantages expected from solid-state circuitry such as instant operation, low current consumption, and cool operation, but also provides extremely low distortion and noise, plus wide frequency response at its full rated power to ensure the finest sound reproduction. Stereo inputs have been provided for reproduction from a wide variety of external program sources that you may wish to use—record players, tape recorders, tape players, etc. Some of the special features that have been incorporated in this receiver to ensure a high degree of performance and to provide complete flexibility of operation are as follows: * 75 ohm and 300 ohm antenna inputs for FM. * Sensitive dual-gate MOS FET in the FM RF section with 4-section variable capacitor. * Three 2-element ceramic filters used in the IF section for high selectivity. * PLL [Phase Lock Loop] IC used in the FM stereo decoder section for optimum stereo performance with minimum distortion. * A newly-developed IC functioning as an IF amplifier, a low-distortion Quadrature FM detector, a driver for the tuning meters, and as a sophisticated FM muting circuit which not only eliminates noise between stations on FM in the conventional manner, but also silences the receiver when not properly tuned to a station. * Dual Meters used — a conventional signal strength meter plus an FM center-tuning meter for precise tuning. * Built-in Dolby Noise reduction circuit for decoding Dolby FM broadcasts. * Two sets of magnetic phono inputs accommodating a range of cartridge output levels from 2.5 mV to 36Q mV [for rated power output]. * Stereo microphone input controlled only by a mic level control for convenient mixing with other program sources. * Two-position turnover frequency switches for Bass and Treble controls. * Direct-coupled OCL power amplifier stages. * Amplifier output stages protected by a dual system of relay and electronic overload protection circuitry. * Quick-connect output terminals for up to three sets of stereo speakers. * 2-position 12 dB/octave Low Frequency Filter switch [15 or 40 Hz]. * 2-position 12 dB/octave High Frequency Filter switch [7 or 12 KHz]. * Dual Tape Monitoring facilities plus special dubbing switch to permit recording from one tape recorder onto another in either direction.