daeg Specifications SPO2 SIMULATION GENERAL Factory installed, downloadable and user programmable R-curves, patient conditions and templates. Probe signal and LED test ACTIVE PROBE SPO2 SIMULATION O2 saturation range: 35 – 100 % Simulation resolution: 1% SpO2% Simulation accuracy: ± 0.5 SpO2% 65-100% SpO2% ± 1 SpO2% 30-64% SpO2% Simulation repeatability: ± 0.2 SpO2% Simulation rate: 30 – 300 bpm Rate resolution: 5 bpm (sync. to ECG for “C-lock” testing) Rate accuracy: ± 0.1% Pulse amplitude 0 – 100% of nominal pleth amplitude. Amplitude resolution: 0-10 range, 1% 10-100 range, 5% Amplitude accuracy: ≥30% amplitude ±1%. 1-29% amplitude ±5%. Pigmentation: Low, medium and high Light repeater bandwidth: DC – 1MHz Optical slew rate: 50 mcd/ s Light repeater dynamic range: 1mcd + 13 dB – 60 dB Receiver optical 3 dB bandwidth: 600 – 1050 nm. INSTALLEDBCI Oxipuls Criticare Nellcor HP Ohmeda R-CURVES ADDITIONAL R-CURVES These are R-Curves that are available and can be uploaded using the PRO-Soft daeg software. BCI Oxipulse 3301 Criticare 504 Dolphin 2100 HP/Philips Massimo Nellcor N-20, N-180, N-200, NBP-40, Symphony Nonin 8500 & Marquette Apex Novametrix Oxypleth Ohmeda 3700, 3740 Welch Allen Propaq INSTALLED PATIENT CONDITIONS Normal patient Geriatric patient Obese patient Patient with weak pulse Bradycardia Tachycardia ARTIFACTS (ACTIVE PROBE ONLY) Motion: 0 - 4Hz Ambient sunlight: Ambient, Sun Interfering light: 50Hz, 60Hz PROBE LED OPTICAL FREQUENCY Frequency range: 550 – 1050 nm Resolution: Accuracy: 1nm ±2% of range