SERIES 1306 AC HIPOT TESTER The “Fail Safe” Hipot Tester • Designed for Go, No-Go Production Line/Quality Control Testing • Meets UL and CSA Requirements Including UL 120K ohm Requirements • Safe, Efficient, Easy-To-Use Retracting Safety Prods for Applying High Voltage • Unique Fail-Safe Reject/HV Cutoff Circuit Disables Tester if Primary Cutoff Fails • 120 K ohm Resistor Terminals on Front Panel for Quick, Easy Calibration Check APPLICATIONS The Slaughter Series 1306 units are simple go, no-go dielectric voltage withstand (hipot) testers that contain all features necessary for tests specified by practically any agency standard. These units are most commonly used as in-tine or final inspection testers by manufacturers of electrical components, assemblies, and complete products such as appliances, computers, and robots. They are also used as troubleshooting tools by design engineers, plant maintenance personnel, and electrical contractors. The instrument is particularly well suited for testing per the new UL ‘*120 K ohm” requirement. The 120 K ohm resistor terminals on the front panel allow the operator to check instrument calibration quickly and easily at any time. The 1306 is an unusually powerful tester for its size and can be used to test ail but the largest electrical products. At 10Ma and 1250 volts, even electric motors up to about 20 horsepower or .02 microfarad should be no problem.