Tektronix - 468 - Oscilloscope
Manufacturer:
Image 1 of 1
If you have any other photos or manuals for the
Tektronix 468
you can
upload the files here.
Equipment:
468
Date:
1984
Category:
Group:
Sub Group:
Information
The TEKTRONIX 468 Oscilloscope is a portable digital storage
oscilloscope with a four-trace, dc-to-100 MHz, vertical
deflection system. The 468 combines an easy-to-use storage
function with cursor measurement of time and voltage.
Measurement values are indicated on a four-digit,
seven-segment LED display.
NON STORE MODE
In the NON STORE mode, the 468 operates as a conventional
oscilloscope that can display CH 1, CH 2, ADD, and A TRIG
VIEW (external trigger only) simultaneously. The vertical
deflection system has calibrated deflection factors ranging
from 5 mV to 5 V per division. The horizontal deflection
system has calibrated A Sweep rates from 0.5 s to 0.02 µs
per division and is capable of operating in the following
sweep modes: A,A intensified by B,A alternated with delayed
B, and B delayed. The calibrated B Sweep rates are from 50
ms to 0.02 µs per division.
The horizontal magnifier circuit feature increases each
sweep rate by a factor of 10. This provides a maximum sweep
rate of 2 ns per division when the TIME/DIV switch is in the
0.02 μs per division position.
STORAGE MODE
The 468 digital storage circuitry has a 10 MHz Useful
Storage Bandwidth for the acquisition of signals, and will
display the acquired waveform with a bright, flicker-free
trace. With the digital storage feature, low-frequency
signal analysis and waveform measurements-previously
difficult or impossible to make-are easily performed. A
choice of two standard and one optional signal acquisition
modes are available: NORM and ENVELOPE (standard) and AVG
(optional). Two storage functions are available to hold a
display indefinitely for measurement and comparison: SAVE
Storage Mode (stops acquisition) and SAVE REF (holds a
reference display and continues acquisition in the selected
Storage Mode). Waveform data may be acquired prior to or
after the trigger using the PRE TRIG or POST TRIG Storage
Window. Time and voltage measurements on the acquired
waveform are easily made using the VOLTS and
REV DEC 1981 468 Operators 1
TIME Cursor Functions, and the measurement values are
indicated on a four-digit, seven-segment light-emitting
diode (LED) display.
1 Manual
Service and user manual
Manual type:
Service and user manual
Pages:
204
Size:
6.1 MB
Language:
english
Revision:
revised
Manual-ID:
070-2906-01
Date:
Quality:
Scanned document, all readable.
Upload date:
Nov. 28, 2014
MD5:
da1d46f7-0e78-4502-c1aa-3aed3f1e2888
Downloads:
739