The AWG400-Series Arbitrary Waveform Generator is a programmable Arbitrary Waveform Generator which has a maximum 200 MS/s, 4 M word per channel waveform memory and 16-bits DAC. Amplitude is programmable up to 2.0 V (Complementary output) or {5 V (Single-Ended output) optional} peak-to-peak into 50 W with independent offset control. The exterior of the AWG400-Series Arbitrary Waveform Generator is similar to the AWG500/AWG600-series product, except that the parameters and operating menus are displayed on an LCD color monitor instead of a monotone CRT (cathode ray tube). The instrument can be manually controlled from the front panel and remotely programmed via a GPIB (General Purpose Interface Bus) or Network. The AWG400-Series Arbitrary Waveform Generator GPIB is compatible with other devices that meet IEEE standard 488.2. The AWG400-Series Arbitrary Waveform Generator allows you to create sine, triangle, square, ramp, and complex waves, as well as direct current and noise signals. It allows you to set waveform attributes, such as frequency, amplitude, and offset. This instrument contains a hard disk drive, a 3.5-inch floppy disk drive, and an Ethernet interface for storing and recalling waveform data and instrument settings. Main Features The AWG400-Series Arbitrary Waveform Generator contains the following main features: 200 MS/s sampling rate 16-bit DA converter 4 M-word waveform memory Two arbitrary marker outputs per channel Five waveform editors