FEATURES Digital Light Processing TM (DLP TM) by Texas Instruments P600DL is a projection unit using the Texas Instruments’ Digital Mirror Device (DMD) TM optical element. The DLP TM, Digital Light Processing TM engine is constructed with the DMD chip, with XGA resolution. Flexible input capability From Video signal (NTSC/PAL) to SXGA 75Hz are compatible. Incoming PC signal timing should be followed the VESA standard. XGA signal is reproduced on screen without having any scaling function. The other frequencies are converted to XGA resolution inside the cube. See note 1. Internal magnification A multi-screen system can be formed easily with an internal magnification function from 1x1 to 6x6 with some popular magnification ratio as 2x3, 3x4 or 4x5. Digital signal link between units The unit has digital I/O interface. A signal supplied to 1st unit, master cube, is distributed to the following cube with DVI digital Link Cable. Signal distributor and other signal cables are not necessary. See Note 2 below. Superior image quality * Native resolution of XGA, 1024x768 pixels * No burn-in unlike projection tube * High Contrast image by 12-degree mirror flip DMD chip Easy installation and maintenance * Convergence free between colors * Steady geometric alignment * Engine installed at factory * Easy replacement 6000H (Survival rate of 50%) UHP 120W lamp, See Note 3 Low power consumption 120W UHP lamp is used for light source. Total power consumption is 200W. Highly reliable control system Projection system can be controlled with a PC via RS232C cable. Also most of the control/adjustment is possible to do with optional wired remote control, CT-90000. RS232C IN/OUT are to send command and also for communication between cubes. Mechanical function Screen escutcheon can be removed from front. Almost all the connection cables can be hidden inside the cube. Note 1: This does not mean that all the signals are accepted. For acceptable signals, refer to the later page in Acceptable Signal Type and also Acceptable RGB input Signal Timing. Note 2: Maximum number of units which can be connected via Digital Signal Link is depend on input signal quality, including S/N and jitter, etc.. Note 3: The lamp is expected to last more than 4000H, with the recent information, it will be more than 6000H, with survival rate of 50%, however, the actual life of each lamp varies depending on conditions of use. For warranty and exchange of lamp, please check with your dealer/distributor.