Tektronix - PG 509 - Generator
Manufacturer:
Equipment:
PG 509
Date:
1989
Category:
Group:
Sub Group:
Information
The
PG 509 Pulse
Generator is a fast-risetime pulse source
producing narrow rectangular pulses at a repetition rate of
50 KHz.The
PG 509 can deliver a continuous pulse train at an
amplitude of 25 volts into an output toad of 50 ohms.
The
PG 509 Pulse
Generator is a TM 500 Series plug-in
instrument. All functional electronics are included, but it
requires insertion in a TM 500 or TM 5000 Series Power
Module Mainframe for interfacing to basic power supplies.
The
PG 509 Pulse
Generator was primarily designed to be an
integral part of a test system. Figure 1-1 shows primary
components and connections immediately related to the Pulse
Generator in a typical system.
Other than the System
Controller, Device Under Test, and PG 509, these are:
• A programmable attenuator (TEKTRONIX AT 5010, or
equivalent); used to provide system selection for the degree
of attenuation required.
• A high frequency multiplexer/switcher (TEKTRONIX SI 5010,
or equivalent); used to route inputs and outputs between
Instruments and test devices while under system control.
Note that while the
PG 509 is not under direct GPIB control,
it is typically directed by instruments that are. In a
mostly
Tektronix instrument configuration, this would
typically mean that the PG509 be installed in a TM 5000
(programmable plug-in compatible) Power Module, as is
required for the other two devices.
Service and user manual
Manual type:
Service and user manual
Pages:
49
Size:
2.6 MB
Language:
english
Revision:
Manual-ID:
070-7755-00
Date:
October 1989
Quality:
Scanned document, all readable.
Upload date:
Dec. 28, 2017
MD5:
8730b807-db3e-5022-514f-ae7703d99734
Downloads:
507