Thurlby Thandar Instruments TTI - TSX Series - Power supply
Manufacturer:
No picture available!
Maybe you can
upload a pic
for the
Thurlby Thandar Instruments TTI TSX Series ?
If you have any other manuals for the
Thurlby Thandar Instruments TTI TSX Series
you can
upload the files here.
.
Equipment:
TSX Series
Date:
2009
Category:
Group:
Sub Group:
Information
OUTPUT SPECIFICATIONS
Output Voltage Range: 0V to 35.3V (35V/10A); 0V to 18.15V
(18V/20A).
Output Current Range: 0.01A to 10.2A (35V/10A); 0.01A to
20.2A (18V/20A).
Output Voltage Setting: Direct keyboard entry or
quasi-analogue rotary control; setting
resolution 10mV.
Output Current Setting: Direct keyboard entry or
quasi-analogue rotary control; setting
resolution 10mA.
Output Mode: Constant voltage or constant current with
automatic crossover.
Output Switch: Electronic. Preset voltage and current
displayed when off.
Output Terminals: 4mm terminals on front panel, screw
terminals at rear.
Sensing: Remote via rear panel screw terminals or direct via
shorting strip
(supplied).
Output Impedance: <1mΩ in constant voltage mode.
>5kΩ in constant current mode (voltage limit at max.).
Output Protection: Forward protection by
Over-Voltage-Protection (OVP) trip;
maximum voltage that should be applied to the terminals is 50V.
Reverse protection by diode clamp for reverse currents up to 3A.
OVP Setting: Direct keyboard entry.
OVP Range: 1V to 40V (35V/10A); 1V to 25V (18V/20A).
OVP Delay: <200μs
Load & Line Regulation: <0.01% of maximum output for 90%
load change or 10% line
change.
Ripple & Noise: <1mV rms typical in constant voltage.
<3mA rms typical in constant current.
HF Common Mode Noise: Typically <3mV rms, <10mV peak.
Transient Response: 20μs to within 50mV of setting for 90%
load change.
Temperature Coefficient: typically <100 ppm/°C.
Protection Functions: Overvoltage trip; regulator
overtemperature; sense miswiring.
Status Indication: Output off lamp; constant voltage mode lamp;
constant current mode lamp; trip message on display.
METER SPECIFICATIONS
Meter Types: Dual 4 digit meters with 12·5mm (0.5") LEDs.
Reading rate 4Hz.
Meter Resolution: 10mV, 10mA
Meter Accuracy: Voltage 0.2% of reading ± 1 digit, current
0.5% of reading ± 1 digit.
KEYBOARD FUNCTIONS
Delta Mode: Increase or decrease voltage or current in
user-selectable steps.
Store/Recall: Store and recall voltage, current and OVP
levels from non-volatile
memory (25 memories).
Interface Selection: Set digital interface type (RS232 or
GPIB), baud rate and address.
User manual
Manual type:
User manual
Pages:
95
Size:
2.0 MB
Language:
english, german, french
Revision:
Issue 12
Manual-ID:
48511-0130
Date:
January 2009
Quality:
Electronic document, no scan, very well readable.
Upload date:
Jan. 14, 2017
MD5:
11956a66-d324-f0e3-355b-44f4cb497be5
Downloads:
573
User manual
Manual type:
User manual
Pages:
95
Size:
867.7 KB
Language:
english, german, french
Revision:
Issue 13
Manual-ID:
48511-0130
Date:
January 2013
Quality:
Electronic document, no scan, very well readable.
Upload date:
Jan. 14, 2017
MD5:
1b73ba08-af63-e918-fc82-89d61fdc62e3
Downloads:
289